PAPER STRENGTH · BUYER GUIDE
Dry vs Wet Strength Agents for Paper
Compare the two product families by service condition, test result and the information needed to shortlist a grade.
Request Strength Agent Data
Which strength property is below target?
Shortlist a dry strength agent when the finished sheet falls short under dry use. Shortlist a wet strength agent when the sheet must retain integrity after wetting. If the purchase specification covers both conditions, carry both test results into the trial and the quotation request.
| Check | Dry strength agent | Wet strength agent |
|---|---|---|
| Service condition | Dry sheet handling or finished-paper use | Exposure to water during converting or use |
| Baseline to share | Agreed dry tensile, burst or other relevant mill result | Wet tensile or other grade-specific wet test, with the wetting protocol |
| Trial checks | Dry result, formation and machine stability | Wet result and machine stability. For tissue, also track softness and absorbency. |
Keep the results comparable
Use the same paper grade, grammage, furnish and agreed test procedure for the baseline and candidate. Record the current wet-end program and addition point. If both properties matter, report both results for each run and flag any change in furnish or process conditions.
For wet tensile testing, confirm the appropriate method with your laboratory. ISO 3781:2011 covers paper and board after water immersion. ISO 12625-5:2024 covers tissue paper and tissue products.
Compare available Aupha Chem product data
Dry Strength Agent
Review the published grade data and define the dry-strength target for screening.
View product specifications →Wet Strength Agent
Review the published cationic resin data and share the wetting conditions and required wet strength.
View product specifications →What to send with an inquiry
- Paper grade, end use, grammage and furnish.
- Dry or wet failure condition, test method, current result and target.
- Current additives, addition point, expected consumption and delivery destination.
For grade-specific tradeoffs, see the packaging strength and sizing guide or the tissue softness and wet-strength guide.
Buyer questions
How should a mill compare grades when both dry and wet strength matter?
Agree on a minimum result for each test. Compare both properties and runnability under the same conditions before choosing a grade.
What should the wet-strength sample request specify?
Give the paper grade, current test result and target. Include the wetting protocol, current wet-end program and the technical data or sample quantity needed.
Discuss a paper strength trial
Share the failure condition and test target so the team can review the relevant product family, grade data and sample requirements.
Request Strength Agent DataBack to the selection overview